User's Manual

Inventor User Guide | www.flashf orge.com 0086‐ 0579‐82273989
67
8‐2
Perimeter
1）Thickness
a . Shell Count: Numbers of laps for each layer’s shell. M aximum: 10; Minimum: 1.
b. Maximum Path Overlap: Max amount of overlapping extrusion for some models,
especially small models.
2
）
Speed:
a. Exterior Speed: Speed at which the exterior shell is printed.
b. Exterior maximum speed: Speed at which the exterior maximum she ll is printed.
b. Visible Interior Speed: Speed at whic h the visible interior shell is printed.
c. Invisible Interior Speed: Speed at which the invisible interior s hell is printed.
3） Start Points
a. Mode: There are two options for Start Point mode. One is “closest to specific
location”, the other i s “use random start points”.
b. X: The coordinate value of X
c. Y: The coordinate value of Y