User's Manual

Inventor User Guide | www.flashf orge.com 0086‐ 0579‐82273989

Method 2: Click the [Rotate] icon on the left, and then enter into rotating

angel values in X/Y/Z axes positioning. Click [Reset] to reset rotating angel values.

6.2.7 Scale

Select the target object and scale the objec t by the following two methods:

Method 1: Click the [Scale] icon on the left, hold down the left mouse button

and scale the model. The corresponding values will display near the object..

Method 2: Click the [Scale] icon on the left and then enter into scale values

in X/Y/Z axes positioning. Click the [Maximum] button to get largest size possible

for building. Click [Reset] to reset the size of model.

Note: If the [Uniform Scaling] radio button is clicked, it will scale t he model in equal

proportion when changing value in any positioning of the model. Otherwise it will

only change the value of the corresponding positioning.

6.2.8 Cut

Left-click on the model to select it and double-click on the Cut icon to set the cut

plane. The direction and position are available for setting.

①

Draw with M ouse