User's Manual

Inventor User Guide | www.flashf orge.com 0086‐ 0579‐82273989
16
3.
（
3-3
）
Lift the Inventor by its side openings and place it on a flat surface. Then
You will see the Expert Kit, power cord,andUSB cable in the shipping box. In the
Expert Kit, you can find a Carving Knife, a Scraper, Tweezers, a Sensor line and
a Screw Box. What's more. a SD card and some screws, Wrenches in the Box.
3-3
4.
（
3-4
）
The Inventor will have an accessory box on top of it, which will house the
extruder set. Remove the box and the foam pad from the Inventor, and gently lay the
extruder set on the Inve ntor build plate.
Inside the accessory box, you will find an SD card, asidefanduct,andtwo pieces
of removable side panels.
3-4
5. (3-5) Move the build plate up ca refully.