User's Manual

Inventor User Guide | www.flashf orge.com 0086‐ 0579‐82273989
15
Chapter 3. Unpacking
(Reference video:Unpacking)
This chapter will present you the whole unpacking procedure of Inventor 3D
printer.(Note: Make sure you read the whole unpacking guide)
1.
（
3-1
）
Put Inventor package on the clean, tidy workbench,using a knife to cut the
tape ,then you can see two quick start guide,which will guide you know our Inventor
3D Printer.
3-1
2.
（
3-2
）
Remove the top protective foam pieces, which also houses the Inventor’s
lid. Set this aside for now. The Inventor unit will then be exposed.
3-2