User's Manual

Hunter User Guide | www.flashforge.com 0086- 0579-82273989
36
①
Support Options
Click the Support Options, an option box will appear, supports options only include
“Columnar”.
Overhang Thresh:The parameters used to judge whether the model surface meed to
generate the supports. The higher the value, the less the supports. The value is
between 30°to 60°.
Tip Diameter: The diameter size of support and model contact parts, the bigger
diameter the stronger support, and harder to remove. The value is between 0.25mm to
1mm.
Post Diameter:The diameter of support post, the larger the diameter of supporting the
stronger it will be, the more difficult to spin off. The value is between 0.25mm to
2mm.
Base Diameter:The diameter of the bottom post, the larger the base diameter the
easier supports stick to the built plate, the more difficult to spin off. The value is
between 0.2mm to 3mm.
Base Height: The height of the support at the bottom of the bold part, the higher the
base height, the stronger support bottom, the more difficult to spin off. The value is
between 0 to 5mm.
Post Space: The spacing among posts, the smaller the value the closer the posts. The
value is between 1mm to 10mm.
Exterior Only:
5-11