User's Manual
Table Of Contents
Hunter User Guide | www.flashforge.com 0086- 0579-82273989
15
Chapter 3. Unpacking
This chapter will present you the whole unpacking procedure of Hunter 3D
printer.(Note: Make sure you read the whole unpacking guide)
1. (3-1)Put Hunter package on the clean, tidy workbench, using a knife to cut the
tape from the bottom.
3-1
2. (3-2)Set the Hunter upright, lay the white foam on the floor and lift the carton.
3-2
3.
(
3-3
)
Remove the foam and accessory box from top. You will find a Quick Start
Guide, an After-Sales Service Card and a Spare Vat Film inside.