User's Manual

GuiderⅡ User Guide | www.flashforge.com 0086-0579-82273989
52
pops up. You need to select “Wi-Fi” in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
6-19
If successfully connected, you will see the following red mark.
②
Connect Guider
Ⅱ
with your PC under STA mode
a. Turn on the WIFI of Guider Ⅱ and connect your PC with GuiderⅡ via the
WIFI. Press [ Tools ], [ Setting ], [ WIFI ], and [ WIFI ON].
b.“GuiderⅡ” continuous signal will be found available on the network list.
c. Once your PC is connected with your GuiderⅡ. Open the Internet browser and
enter “10.10.100.254” and enter the default user name(admin) and
password(admin).
6-20