User's Manual

GuiderⅡ User Guide | www.flashforge.com 0086-0579-82273989
25
Chapter 4: Hardware Assembly
Your GuiderⅡ has been installed before leaving factory, you can start up the GuiderⅡ
for printing after mounting the filament spool and completing leveling.
4.1 Filament Installation
4-1
(4-1) The filament cartridge is at the rear of Guider Ⅱ . Lift the cartridge out of the
Guider
Ⅱ
.
4-2
(4-2) Take out the filament and thread it through the filament detecting equipment.
Filament Detecting
Equipment in the black.