User's Manual

GuiderⅡ User Guide | www.flashforge.com 0086-0579-82273989
17
Tap [Setting] to enter the setting interface
 Language: To set the display language
 Resume Print: Resume print after
restarting Guider II
 WLAN: To turn on/off the Wlan
 Wlan hotspot: To turn on/off the Wlan
hotspot.
 Servo Calibration: To turn on/off the
servo or adjust the servo.
Extruder Calibration: To adjust the initial
distance between the extruder and the
build plate.
 Filament Check Off: To turn on/off the
filament check
 Factory Reset：return to factory setting
Update: To update the firmware version.
Return arrow
WIFI:
Turn on WIFI: Turn on the WIFI, release
the WIFI hotspot and set the WIFI on
computer
Return arrow