Quick Start Guide

12
Software Operation
1. Install and run the FlashDental.exe program.
3. Use movement and rotation to place the
model in an appropriate position. The
model should not be lower than the
network surface of the bottom plate.
5. Click [OK], select the file type ".svgx ",
select the save location, and click
[Save S].
6. At this point, "Slicing..." will be displayed
at the bottom of the interface. , after the
section is completed, the interface changes
into the section preview interface.
4. Click Print, and a print window pops up.
(Generally just adjust "layer thickness",
"bottom number", "exposure time",
"bottom exposure time", etc.)
2. Click Load, select the model file.
FlashDental.exe Load
Set Position
X:
Y:
Z:
0.00mm
0.00mm
0.00mm
On Platform Separately
On Platform Center
Reset
FlashDental
Move
Rotate
Slicing model ...
Print
I want to:
Material Type: Dental Model Resin
Layer Height:
More Options >>
Base Time: 2.6s
20.0s
8
Attach Time:
Gradual Time Layers:
Restore Defaults
OK Cancel Save Configuration
RaftExposure Time
Infill OthersSize Adjust
0.05mm
Save As New Remove
Operation:
Preview
Print When Slice Done
FlashDental - untitle.fdg
FlashDental
File(F)
Move
Rotate
Cut
Load
Supports
Auto Layout
Print
Edit(E) Print(P) View(V) Help(H)
X
Z
Y