User's Manual



Finder User Guide | www.flashforge.com 0086-0579-82273989
63
 After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.












7.2.3Print from USB Flash Disk
ķInsert your USB flash disk with target .g or .gx file to your Finder. .
ĸTurn on the Finder. Make sure the build plate has been leveled and the filament is
loaded.
ĹTap[Print]and then tap the SD Card icon in the middle. The file(s) will be displayed
on the screen.Select the file you want to print and tap[Print]. The file will be
transferred to the printer.
ļAnd the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort
˖
To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause
˖
To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.

7-11