User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989
73
and laying down material layer by layer to create an object. Many sophisticated 3D
print designs require materials to be deposited on a layer where there was not a
previous layer, or the designs have steep angles which might cause undesired
drooping during the print. In these cases, support structures are needed to ensure
objects integrity and print quality.
①Principle of 45 Degrees
Generally speaking, if the 3D model has an overhang of more than 45 degrees, you
will need supports. This angle is determined by the material, layer height, extrusion
width, and temperature. It is critical to adjust the support structures accordingly to
ensure the best print result, especially for large 3D prints.The principle is raised by a
stage designer and widely accepted among the 3D printing industry.
②Principle of Proportionality
As for the application of supports, the users are suggested to comply with the
principle of proportionality. Even though the supports algorithm has been developing,
adding supports intelligently cannot be realized at present. Therefore, users are always
oriented in adding the supports. As we all know, excessive supports will definitely
result in difficulty in supports removal, while limited supports cannot ensure the
stability of the model. Since FashPrint has the function of manual modification, users
can add proper supports to their models according to the daily experience and the
academic principles.
●Support Types
Linear Support Structure：Suitable for models with large-area overhang(s).
Features：Full coverage of supports improves the model stability. But the supports on
the surface are difficult to be removed and will definitely reduce the print quality.
Treelike Support Structure：Suitable for models with small area overhang(s).(You
are suggested printing a raft)