User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989

Wi-Fi, and enter the “IP Address, Port”as shown on printer LCD screen. Then,click

[ Connect ].

10. If successfully connected, you will see the following red mark.

① Connect Inventor with your PC under STA mode

a. Turn on the WIFI of Inventor and connect your PC with Inventor via the WIFI.

② Disconnect Inventor

Click[Print]--[Disconnect] to disconnect your PC and Inventor.

6.2.14 Tool Menus

①Control Panel

After connecting PC with Inventor, click[Tools]--[Control Panel] to open the control

panel.

● Jog Controls

a. Jog Mode：Select the distance that extruder/build plate move a single time (that is,

the distance extruder/build plate move upon your single click).