User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989

Allows users to redo the most recent edit you have undone to your model file by the

following two methods

Method 1: Click [Edit]--[Redo]

Method 2:Press the shortcutCtrl+Y.

③Empty Undo-stack

To clean up the recorded operating steps so as to release the memory.

④Select All

By the following two methods, you could select all models in the scene.(Whenmodels

are too small to be seen or out of viewing scope, please click

[Center]and[Scale]buttons to adjust the model.)

Method 1: Click [Edit]--[Select All].

Method 2: Pressthe shortcut Ctrl+A.

⑤Duplicate

Select the object and duplicate the object through the following two methods:

Method 1: Click [Edit]--[Duplicate]

Method 2: Press the shortcut Ctrl+D

⑥ Delete

Select the object and delete the object through the following two methods:

Method 1: Click [Edit]--[Delete]

Method 2: Press the shortcut Delete

⑦ Surface to Platform

After selecting the model, you can make the model surface to platform via the following

operation.

Click [Edit]--[Surface to Platform]into surface to platform mode(6-18)