User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989
18
Chapter 4 . Hardware Assembly
TheInventor comes pre-assembled and is almost ready-to-print (ARP).All you need to
do is set the appropriate voltage, mount the extruderset, and install the filament. It will
only take between 5 to 10 minutesbefore you can fire up the Inventor and prepare for
your first 3D print!
4.1 Mounting the Extruder Set
4-1
(4-1) Lay the extruder set on top of theextruder seat with the two extruder fansfacing
the front.
(4-2) Secure the extruder set onto theextruder seat by using two M3x12 fromthe bottom
up.
4-2