User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989
16
3. （3-3）Lift theInventor by its side openingsand place it on a flat surface. ThenYou
willsee the Expert Kit, power cord, andUSB cable in the shipping box.In the Expert
Kit, you can find a Carving Knife, a Scraper, Tweezers, a Sensor line and a Screw
Box. What's more. a SD card and some screws, Wrenches in the Box.
3-3
4.（3-4）TheInventor will have an accessorybox on top of it, which will house
theextruder set. Remove the box and thefoam pad from theInventor, and gentlylay the
extruder set on theInventor buildplate.
Inside the accessory box, you will findan SD card, a side fan duct, andtwo pieces of
removable side panels.
3-4
5. (3-5) Move the build plate up carefully.