User's Guide

Inventor User Guide |www.flashforge.com 0086- 0579-82273989
15
Chapter 3. Unpacking
(Reference video:Unpacking)
This chapter will present you the whole unpacking procedure ofInventor 3D
printer.(Note: Make sure you read the whole unpacking guide)
1. （3-1）PutInventor package on the clean, tidy workbench,using a knife to cut the
tape ,then you can see two quick start guide,which will guide you know ourInventor
3D Printer.
3-1
2. （3-2）Remove the top protective foampieces, which also houses theInventor’slid.
Set this aside for now. TheInventorunit will then be exposed.
3-2