User's Manual

01 02
03
04
05
06
07 08
09 10
11 12 13 14
15 16 17
18
3.
Follow the filament loading direct strictly(as showed) and insert the filament into the
intake. It needs to press the handle to push filament into filament feeding roller until
certain resistance is sensed.
Note：Please ensure the filament direct is the same as the picture showed, or it will
cause the print failure.
Power On
Plug in the power cord and toggle the switch to turn on the power. Do not disconnect
the cables when Aries is powered on.
Attention
· Damage might occur if voltage setting is
incorrect. Make sure the current input
voltage matches to your local power
supply (115/230V).
· Plug in power cord and turn power
switch to 1 to turn it on.
2019 21 22