Quick Guide

Thermal imaging monocular S243

Quick guide

Resolusion

S243：384*288

S242：240*180

Profile

Power

 Long press for 3 seconds to turn on/off the thermal imaging monocular, and then

green indicator light will be on.

 Short press after booting to display the eyepiece dormancy, then press any key to

wake up.

Laser

 Short press to switch the laser indicator.

 Long press for 3 seconds to enter the user menu.

Zoom

 Short press for single zoom, long press for continuous zoom, 1~4 times cycle.

Lens

(lens cap)

Diopter

adjustment

Charging, data, video

Power Indicator

Eyepiece/display

Power, laser, zoom,

camera

Laser indicator

PAGE 1
Thermal imaging monocular S243 Quick guide Resolusion S243：384*288 S242：240*180 Profile Power Indicator Eyepiece/display Power, laser, zoom, camera Diopter adjustment Lens (lens cap) Charging, data, video Laser indicator Power  Long press for 3 seconds to turn on/off the thermal imaging monocular, and then green indicator light will be on.  Short press after booting to display the eyepiece dormancy, then press any key to wake up. Laser  Short press to switch the laser indicator.
PAGE 2
Camera  Short press for camera, long press to start recording, short press again to end recording. Diopter adjustment  According to the individual's degree of myopia, adjust the knob diopter.  USB charging/data port  Open the port cover at the bottom of the monocular and insert the USB charging cable to charge (charging time is about 3~4 hours, with DC5V).  when charging, the red indicator light is on, and when completed the green indicator light is on.
PAGE 3
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.