RS5 series infrared thermal imaging riflescope Quick Guide Product buttons introduction Photo/ video Zoom in/ correct Color code/ menu Power /hibernate Eyepiece adjust Lens adjust Battery compartment Type‐C port
Camera recording status Azimuth display Horizontal tilt angle value Menu location Calibration Parameter Values Remaining storage capacity Color code status E zoom status WIFI statu Battery status Power Long press to turn on/off the thermal imager. After power on, short press to make the eyepiece hibernate, and press any key to wake it up. When setting calibrating data , short press to turn on/unfreeze the image function. Colour code Short press to switch colour scale.
Zoom in Short press for electronic zoom, 1X, 2X, 4X cycle zoom. Long press to enable manual image uniformity correction. Photo Short press to take pictures. Long press to start the recording function, and short press again to end the recording. Function key combination Press and hold the "Zoom in" key and the "Photo" key at the same time to enable or disable the horizontal tilt angle value.
or the "Photo" key to turn this function on or off, and it is turned on by default. Picture-in-picture function: the centre area is enlarged by 2 times by default. When the electronic zoom is activated at the same time, the picture-in-picture image is enlarged cyclically by 2X, 4X, and 8X. Press the "Zoom in" key or the "Photo" key to turn this function on or off, and it is turned off by default.
the screen. Press the "Zoom in" key or the "Photo" key to turn this function on or off, and it is turned off by default. Note: When the hot spot tracking function is turned on, the electronic zoom operation cannot be performed at the same time. Cursor typesetting: ten cursor types can be selected (1~10), and no cursor mode (0) can be selected.
Calibre: You can select the calibration calibre size (Imperial), the range is 0.20~1.80. Press the "Zoom in" key or the "Photo" key to change the parameters, and press the "Color mode" key to select and return. Distance: Selectable calibration distance, 25/50/100. Press the "Zoom in" key or the "Photo" key press the "Color mode" key to change the parameters, and to select and return. Cross reticle: You can move the red cross reticle to the target point.
parameters, and press the "Color mode" key to confirm saving and exit. Sleep setting: The optional automatic sleep time is 0min, 5min, 30min, and 60min. The screen will automatically sleep if there is no operation during this time period. Press any key to restore the sleep state. The default factory setting is 0min. Press the "Zoom in" key or the "Photo" key switch the time, and press the "Color mode" key to to confirm saving and exit.
System upgrade: version upgrade is available. The filename of the version upgrade program is "bin", which can be downloaded from the PC (for details, please contact the manufacturer's after-sales technical support). Copy the program to the root directory of the instrument's local storage space, press the "Zoom in" key or the "Photo" key to switch between "YES" and "NO", and short press the "Color mode" key to confirm.
When in use, open the Type-C interface cover of the device and insert the configured cable, which can be connected to the display on the monitor or other long-distance transmission. Notes: Because the uncooled infrared telescope uses a very sensitive thermal sensor, under any circumstances (on or off), the lens must not be aimed directly at a strong radiation source (such as the sun, direct laser beam or reflection, etc.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
