User's Manual

31
Figure 3-6
After charging is completed, disconnect it from the power socket, and then press stop Step 8
button on the charger to turn off the charger.
3.3.2 Remote Control Charging
The entire charging period (from 0 to full) needs approximately 3.5 hours.
Please charge the remote control when its power is off.
Connect DC: connect the remote control and power adapter with a charging cable. Step 1
Figure 3-7
Connect AC: connect power adapter with AC power (AC 100V- AC 240V). Step 2
Check charging state: it means the remote control is charging when the indicator light is Step 3
red and normally on. It means charging is done when the indicator light becomes green
and normally on, as shown in Figure 3-8.
Figure 3-8
Disconnect it from the power socket, and then disconnect other cables after charging is Step 4
completed.
3.4 Prepare Airborne Device
 The following chapter is optional for operation. It is for your reference when airborne device
shall be replaced.
 This chapter introduces operation of airborne device with PTZ camera as an example.