Quick Start Guide
Configuration 12
Main interface Figure 3-3
Select Local Setting > Basic. Step 2
The device properties are displayed. See Figure 3-4.
Device properties Figure 3-4
In the VTO No. input box, enter the VTO number you planned for this VTO, and then Step 3
click Confirm to save.
3.3.3 Configuring Network Parameters
Select Network Setting > Basic. Step 1
The TCP/IP information is displayed. See Figure 3-5.
TCP/IP information Figure 3-5
Enter the network parameters you planed, and then click Save. Step 2
The VTO will reboot, and you need to modify the IP address of your PC to the same
network segment as the VTO to log in again.