Quick Start Guide

6
3 Configuration
This chapter introduces initialization, cable connection, and parameter configuration to realize basic
functions, including device management, calling, and monitoring.
Configuration Process
Before configuration, make sure that there is no short circuit or open circuit.
Plan IP address for every device, and also plan the unit number and room number you need.
Configure door stations (VTO). For details, see the IP Indoor Monitor_User’s Manual.
1) Initialize VTO.
2) Configure VTO number.
3) Configure VTO network parameters.
4) Configure SIP Server.
5) Add door stations (VTO) to the SIP server.
6) Add room number to the SIP server.
Configure indoor monitor (VTH).
Commissioning.
VDPConfig
You can download the "VDPConfig" to initialize devices, change IP address and upgrade system for
multiple devices at the same time. For the detailed information, see the VDPConfig user's manual.
Configuring Indoor Monitor
When the indoor monitor is used for the first time, you need to select a language that you prefer,
initialize the indoor monitor to get a password to enter project setting interface and an email to reset
password. In addition, you need to configure parameters for all door stations (VTO) and indoor
monitors that are found on the indoor monitor you are operating.
3.3.1 Initialization
3.3.1.1 Quick Configuration for VTH (For Villa)
Power on the device.