Quick Start Guide

6
3 Configuration
You need to configure IP, Wi-Fi, door station parameter, SIP server, and more on the indoor
monitor, and then the indoor monitor can communicate with door stations and the management
center.
Configuration Overview 3.1
Plan the location for the SIP server and plan IP and numbers for each door stations and Step 1
indoor monitors.
Make sure that the there is no short circuit and open circuit. Step 2
Configure parameters for door stations. Step 3
Add indoor monitors to the SIP server. Step 4
Configure parameters for indoor monitors. Step 5
Commissioning. Step 6
Indoor Monitor Configuration 3.2
3.2.1 Initialization
Set password and email.
 Password: Used when administrators need to go to the project mode.
 Email: Used when you need to reset the password.
The default IP address of the indoor monitor is 192.168.1.108.
Connect the indoor monitor to power source. Step 1
WELCOME is displayed, and then the initialization interface is displayed.
Enter the password, confirm password, and email. Step 2
Tap OK. Step 3
The main menu is displayed.