Operation Manual

Dahua 2 Inch PTZ Camera Web 3.0 Operation Manual

Parameter

Function

Send Email

If you enabled this function, System can send out email to alert you

when alarm occurs and ends. User can set email address in

Network>SMTP.

PTZ

 Here you can set PTZ movement when alarm occurs. Such

as go to preset x when there is an alarm.

 The event type includes: preset, tour and pattern.

Snapshot

You need to check the box here so that system can backup motion

detection snapshot file. You shall set snapshot period in

Storage>Schedule.

The zone setup interface is shown as Figure 4-. Different colors represent different areas. Each area

can set different detection zones. Detection zone cam be irregular and discontinuous. If device

monitoring zone is large, user can sub-divide the area into several zones for better motion detect.

Please refer to the following sheet for detailed information.

Parameter

Function

Name

Default area name includes Region0, Region1, Region2,

Region3 and custom.

Sensitivity

It is sensitivity of brightness as motion detection is more possible

to be trigger with high sensitivity. You can set up to four areas.

The range is 0~100. The recommenced value is 30~70.

Area threshold

It is to check target object area related to detection area. The

lower the area threshold, the easier to trigger motion detection.

You can set up to four areas. The range is 0~100. The

recommenced value is 0~10.

Waveform

Red means motion detect is triggered. Green means motion

detect is not triggered.

Delete all

Clear all areas.

Delete

Delete selected area.

4.5.2 Abnormality

Abnormality includes SD Card (Figure 4-65 to Figure 4-67), network (Figure 4-68 to Figure 4-69), and

Unauthorized Access (Figure 4-70).

Note: Only device with SD card function has these three statuses: No SD card, capacity warning, and

SD card error.