Operation Manual

Dahua 2 Inch PTZ Camera Web 3.0 Operation Manual

Figure 4-64

Please refer to the following sheet for detailed information.

Parameter

Function

Enable

You need to check the box to enable motion detection function.

Working Period

Here you can set arm/disarm period. Click set button to open

period setup menu. See Figure 4-.

There are six periods every day for setup and you must check

box in front of each period to enable it.

Note: Period setup can be done by dragging mouse while not

release left mouse.

Anti-dither

System only memorizes one event during the anti-dither period.

The value ranges from 0s to 100s.

Area

Here you can set motion detection region and its sensitivity and

area. (The higher the sensitivity is, the easier to trigger motion

detect; the smaller the area, the easier to trigger motion detect.)

The default covers all regions. You must click save before

enabling your setup. See Figure 4-.

Record

Check it and so when alarm occurs, system will auto record.

You shall set record period in Storage>Schedule and select

auto record in record control interface.

Record Delay

System can delay the record for specified time after alarm

ended. The value ranges from 10s to 300s.