Operation Manual

Dahua 2 Inch PTZ Camera Web 3.0 Operation Manual
50
Figure 4-35
Please refer to the following sheet for detailed information.
Parameter
Function
Authentication
The login authentication is off by default.
4.3.4 PPPoE
The PPPoE interface is shown as in Figure 4-36.
Input the PPPoE user name and password you get from the IPS (internet service provider) and enable
PPPoE function. Please save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN from
the IP address column. When PPPoE is on, please disable UPnP to avoid influence on dial-up.
When you Check PPPoE enable, please disable UPnP.
Please note, you need to go to the IP address item to via the device current device information.
You can access the client-end via this address.