Quick Start Guide

Quick Start Guide
13
Adjust the detection angle and tighten the screws
When adjusting the detection angle of the Radar, you can check the angle by enabling
the device attitude on the web client. It is suggested that the angle of the device should
be –3°, and the equipment should face the middle of the area to be monitored. See "4.2
Adjusting Radar Direction" for details.
Verification after the Installation
After the installation and all the wires are connected, verify if the Radar can work normally.
Follow the standards below:
 Power indicator light is on solid green after the Radar is powered.
 Status indicator light is on solid green after the Radar starts.
 Network indicator light is on solid yellow after network is connected.