User's Manual

81
Parameter
Description
end address of the segment to be added.
MAC address: Enter MAC address of the host to be added.

All IP addresses: Set all IP addresses in trust list or banned list.

IP Version
IPv4: Enter IP address in IPv4 format, such as 192.108.1.125.

IPv6: Enter IP address in IPv6 format, such as

aa:aa:aa:aa:aa:aa:aa:aa.
Device All Ports
Set access ports. You can select all ports or the ports in defined range.
Device All Ports: Set all IP port in trust list or banned list. When

selecting BannedList in Mode, and All IP Address in Rule Type,
you cannot select Device All Ports check box.
Device Start Server Port and Device End Server Port: Set

device start server port and device end server port, and the
range is 1–65535.
Device Start Server Port
Device End Server Port
Step 3 Select OK, and the Firewall interface is displayed.
Step 4 Click Save.
4.5.7 Default
Restore the radar to default configurations or factory settings.
Select Setting > System > Default.
The Default interface is displayed. See Figure 4-76.
Default Figure 4-76
 Click Default, and then all the configurations except IP address and account management will
be restored to default.
 Click Factory Default, and all the configurations will be restored to factory settings.
4.5.8 Import/Export
Export the system configuration file to back up the system configuration. Import system
configuration file to make quick configuration or recover system configuration.
The map you imported in linkage configuration cannot be imported or exported.
Select Setting > System > Import/Export.
The Import/Export interface is displayed. See Figure 4-77.