User's Manual

57
4.3.2.5 Scene Changing
When scene changing happens, the alarm will be triggered. See conditions below.
 The vertical detection range of the radar is covered for more than 50%.
 The radar is rotated for more than 30. But in open areas, 30 rotation of the radar might not
trigger the alarm.
Select Setting > Event > Abnormality > Scene Changing. Step 1
The Scene Changing interface is displayed. See Figure 4-43.
Scene changing Figure 4-43
Select Enable check box to enable scene changing alarm, and then configure other Step 2
parameters as needed. For details, see Table 4-18.
Click Save. Step 3
Storage 4.4
This chapter introduces configurations of schedules for records, snapshots, and holiday, storage
methods, and record control.
4.4.1 Schedule
You can configure schedules of records, snapshots, and holidays.
Before configuring schedule, set Record Mode as Auto in Setting > Storage > Record Control. If
you select Off, the system will not record video or take snapshot as scheduled.
4.4.1.1 Record Schedule
The system starts or stops video recording as scheduled.
Select Setting > Storage > Schedule > Record. Step 1
The record schedule interface is displayed. See Figure 4-44.