User's Manual

4.2.3 PPPoE

Point-to-Point Protocol over Ethernet, it is one of the protocols that device uses to connect to the

Internet. Get the PPPoE username and password from the Internet service provider, set network

connection through PPPoE, and then the device will acquire a WAN dynamic IP address.

Select Setting > Network > PPPoE. Step 1

The PPPoE interface is displayed. See Figure 4-25.

PPPoE Figure 4-25

Select Enable, and then enter username and password. Step 2

Click Save. Step 3

4.2.4 DDNS

Properly configure DDNS, and then the domain name on the DNS server matches your IP address

and the matching relation refreshes in real time. You can always visit your device with the same

domain name no matter how much your device IP address changes.

Before making configurations, please check if your radar supports the DNS server.

 Third party server might collect your device information if DDNS is enabled.

 Register and log in to the DDNS website, and then you can view the information of all the

connected devices in your account.

Select Setting > Network > DDNS. Step 1

The DDNS interface is displayed. See Figure 4-26.