User's Manual

40
Table 4-9 Command list
Parameter
Description
Windows syntax
Arp -s <IP Address> <MAC>
Ping -l 480 -t < IP Address >
Example:
Arp -s 192.168.0.125 11-40-8c-18-10-11
Ping -l 480 -t 192.168.0.125
UNIX/Linux/Mac
syntax
Arp -s <IP Address> <MAC>
Ping -s 480 < IP Address >
Example:
Arp -s 192.168.0.125 11-40-8c-18-10-11
Ping -s 480 192.168.0.125
Win7 syntax
netsh i i show in
netsh -c “i i” add neighbors ldx <IP Address> <MAC>
ping -l 480 -t < IP Address >
Example:
netsh i i show in
netsh -c “i i” add neighbors 12 192.168.0.125
11-40-8c-18-10-11
ping -l 480 -t 192.168.0.125
Power off and restart radar or restart the device by network. Step 4
Check the PC command line. If information such as "Reply from 192.168.0.125…" is Step 5
displayed, the configuration has succeeded, and then you can close the command line.
Enter http://(IP address) in the browser address bar to log in. Step 6
4.2.2 Port
This section introduces configurations of the maximum number of users that can connect to the
radar simultaneously and value of each port.
Select Setting > Network > Port. Step 1
The Port interface is displayed. See Figure 4-24.
Port Figure 4-24
Configure port parameters. See Table 4-10. Step 2