User's Manual

39
Parameter
Description
Mode
DHCP: The system acquires IP address automatically. You cannot set the IP

address, subnet mask and default gateway.
Static: You need to configure IP address, subnet mask and default gateway

manually.
MAC Address
Display the MAC address of radar.
IP Version
Select IP version from IPV4 and IPV6 and both versions can be accessed.
IP Address
Enter the IP address, subnet mask, and default gateway as needed when
selecting Static mode.
 IPV6 has no subnet mask.
 The default gateway must be in the same network segment with the IP
address.
Subnet Mask
Default Gateway
Preferred DNS
IP address of the preferred DNS.
Alternate DNS
IP address of the Alternate DNS.
Enable ARP/Ping
to set IP address
service.
Select the check box, get the device MAC address, and then you can modify
and configure the device IP address with ARP/ping command.
It is enabled by default. During restarting, you will have no more than 2 minutes
to configure the device IP address by a ping packet with defined length, the
server will be turned off in 2 minutes, or it will be turned off immediately after
the IP address is successfully configured. If the service is not enabled, the IP
address cannot be configured with ping packet.
Click Save. Step 3
A demonstration of configuring IP address with ARP/Ping
Keep the device that needs to be configured and the PC within the same LAN, and then get Step 1
an IP address available.
Get the physical address of the radar from its label. Step 2
Open command editor on the PC and enter the following command. See Table 4-9. Step 3