User's Manual

Network 4.2

This chapter introduces network configuration.

4.2.1 TCP/IP

You can configure IP address, DNS (Domain Name System) server of the radar to make sure that it

can be mutually connected to other devices in the networking.

 Confirm the radar has connected to network correctly before setting network parameters.

 Allocate IP address of the same network segment if there is no router in the network.

 Set corresponding gateway and subnet mask if there is a router in the network.

Select Setting > Network > TCP/IP. Step 1

The TCP/IP interface is displayed. See Figure 4-23.

TCP/IP Figure 4-23

Configure parameters. See Table 4-8. Step 2

Table 4-8 TCP/IP parameter descriptions

Parameter

Description

Host Name

Enter host name, 15 characters at most.

Ethernet Card

Select the Ethernet card that needs to be configured. The default one is Wire.

You can change the default Ethernet card if there is more than one card. Restart

radar to activate the new settings once you modify the default settings.