User's Manual

Select a target point (More than 10 m away from the camera is recommended) with 5)

the same height as the lens. Adjust monitoring image of the camera by using PTZ

control icons to move the crosshair to the target point, and then click Acquire

calibration value.

Enable Alarm Track on the interface, and then click Save. 6)

4.1.4 Region Management

You can add different types of regions, draw alarm, pre-warning, or shield areas, set arming periods,

filter objects in regions, and more.

Select Setting > Radar Settings > Region. Step 1

Region Figure 4-16

Click to add regions. Regions are enabled by default. Step 2

Double-click the name under the Name column to modify the region name. Step 3

Select Area Type from Intrusion and Tripwire. Step 4

 Intrusion: When the target enters, leaves, or appears in the detection area, the system

performs alarm linkages.

 Tripwire: When the target crosses tripwire from the defined motion direction, the

system performs alarm linkages.

Click Draw Rule to draw a line or an area within radar detection range. Step 5

Click the left mouse button to start drawing, and then click the right mouse button to end

drawing.

The area you draw can exceed the edges of the detection region.