User's Manual

31
 You must log in to the PTZ camera before calibration. For details, see "4.1.2 PTZ
Camera".
 If you need to link multiple cameras, click PTZ Camera List at the upper-left corner
above the live image to switch to another camera, and then repeat the following
steps.
Log in to the camera Figure 4-15
Enter the installation height of the camera. Step 2
Enter the height of the lens; otherwise the camera-radar linkage effect will be reduced.
Select Close to turn off Alarm Track; otherwise you cannot calibrate the camera. Step 3
Select installation methods from Separate and Integrated. Step 4
Add radar coordinates to calibrate radar. Step 5
 Set coordinates 10 m–20 m away from the PTZ camera and make sure they are
within the radar detection range.
 Two people are required: Person A is on the site, and Person B doing configurations
on the Web. Keep A and B stay in contact.
Double-click the map to enter full screen, and then click to add radar coordinates. 1)
A walks until a green track appears. 2)
After A stops, the track of A will disappear and turn into an orange static track point.
Aim to the feet of A and adjust the PTZ camera image to make sure the target 3)
takes up 1/2 of the image.
Click to save the settings. 4)
For separate installation, repeat the above steps to add the second set of radar
coordinate. PTZ camera and the two sets of coordinates must not on the same
straight line.