Users Manual Part 1


25
Name
Function
A
RS
-485
communication port
RS485_A port. It is the cable A. You can connect
to the control devices
such as speed dome PTZ.
B
RS485_B. It is the cable B. You can connect to the
control devices such as speed dome PTZ.
CTRL (CTRL 12 V)
—
Controller 12 V power output. It is to control the
on
-off alarm relay output. It can be used to
control the device
alarm output. At the same
time, it can also be used as the power input source
of some devices such as the alarm detector.
P (+12 V)
—
+12 V power output port. It can provide the power
to some peripheral devices such as the camera or
the alarm device. Please note the supplying power
shall be below 1 A.
RS
-232
RS
-232 debug COM
It is for general COM debug to configure IP
address or transfer transparent COM data.
VGA
VGA video output port
VGA video output port. Output analog video
signal. It can connect to
the monitor to view
analog video.
PoE PORTS
—
Built
-in Switch. Support PoE or ePoE function.
For ePoE series product, port 1 to port 8 are the
ePoE ports. ePoE port supports 300
meters@100Mbps, 800 meters@10Mbps. Port 9
to port 16 are general PoE ports.
T
he 16 PoE series supports total 150W.
2.2.6 4K 1U (S2) Series
The general 4K 1U (S2) series rear panel is shown as below.
Figure 2-43 Rear panel

The 4K 1U (S2) with 4 PoE ports series rear panel is shown as below.
Figure 2-44 Rear panel

The 4K 1U (S2) with 8 PoE ports series rear panel is shown as below.