Users Manual Part 1


92
Parameter
Description
Default Ethernet Port
two network adapters is disconnected, the system network
status is regarded as offline.
●
Fault Tolerance: Two network adapters share one IP address.
Normally only one network adapter is working. When this
adapter fails, the other network adapter will start working
automatically to ensure the network connection.
ƺ
When you test the network status, the network is regarded as
offline only when both network adapters are disconnected.
ƺ
The two network adapters are used under the same LAN.
●
Load Balance: Two network adapters share one IP
address. The
two adapters work at the same time to share the network load
averagely. If one of them fails, the other can continue working
normally.
ƺ
When testing the network status, the network is regarded as
offline only when both of the two network adapters are
disconnected.
ƺ
The two network adapters are used under the same LAN.
The Device with single Ethernet port d
oes not support this function.
IP Version
Select
IPv4 or IPv6. Both versions are supported for access.
DHCP
Enable the system to automatically obtain a dynamic IP address.
MAC Address
Displays the MAC address of the Device.
IP Address
●
Enter the IP address and then configure the corresponding
subnet mask and default gateway.
●
After configuration, click Test
to check whether there is conflict
in IP address.
IP address and default gateway must be on the same network
segment.
Subnet Mask
Default Gateway
To unbind NIC, on the TCP/IP page, click . The unbinding will take effect after the
Device restarts.
2) On the TCP/IP page, configure DNS server. This step should be performed when you
enable the domain name service.
You can get DNS server address or manually enter it.
● Automatically get DNS server address: When there is a DHCP server in the network,
you can enable DHCP, and then the Device gets a dynamic IP address.
● Enter DNS server address: Select IP Version, and then configure the preferred DNS
server and alternate DNS server.