User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
85
Net load
Click the network that you want to view. The data receiving speed and sending speed
information are displayed.
NOTE
By default, the network load of eht0 is displayed.
The green line represents data sending speed, and the red line represents data
receiving speed.
4.6.3 Configuring platform
4.6.3.1 Setting up auto registration
After successfully auto registered, when the device is connected into the Internet, it will report
the current location to the specified server to make it easier for the Client software to access
the Device, and to preview and monitor it.
Select PLATFORM > REGISTER
The Auto Registration interface is displayed. See Figure 4-69.