User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
82
Data usage
4.6.2.3 Configuring Switch Settings
After setting up the SWITCH, the device automatically allocates IP addresses to the IPC
directly connected to the PoE port of the device.
CAUTION
By default, the Switch Settings check box is enabled. The network segment is 10.1.1.1. It
is recommended to keep the default setting.
If the IP camera is from the third party, it must support the Onvif protocol and has
enabled DHCP.
In the main menu, select SYSTEM SETUP > NETWORK > SWITCH.
The Switch interface is displayed. See Figure 4-66.