User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
80
4.6.2.2.1 Setting 3G Parameters
Preconditions
Make sure the Device is equipped with 3G module and inserted with SIM card from the
Communication Operator.
The dial number, user name, and password have been obtained from the
Communication Operator.
Steps
Select Main Menu > NETWORK > 3G > 3G.
The 3G interface is displayed. See Figure 4-63.
3G
Select 3G Network, click to enable the network. This function is enabled by
default.
Configure TCP/IP parameters. For details, see Table 4-18.
Table 4-18 3G setting parameters description
Name
Description
NetAccess
When the Device is accessed to private network, click to enable
NetAccess check box, enter APN name and select authentication mode.
If PAP or CHAP is selected for AUTH, enter user name and password,
then the Device is automatically accessed to private network
Network Type
When enabled, the network type is displayed, which is used to distinguish
the 3G modules among Communication Operators, such as TD-LTE
APN
Displays access point of Communication Operator.
To manually set up APN, select
Customized