User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
66
Name
Description
Health Enable
The system sends test mail to check if the connection is successfully set
up
Select the Health Enable check box, and then enter the interval. The
system can send a test email to check the connection after the specified
interval
NOTE
The value ranges from 30 minutes to 1440 minutes
Click Apply.
Click Test to test if emails can be sent out and received as intended after
configuration. If the configuration is correct, you would receive test email.
4.5.1.7.2 Configuring Email Linkage
Enter the alarm configuration interface, and select Send Email. See Figure 4-46.
Mail sending
4.5.1.7.3 Result Verification
When an alarm is triggered, the system sends an alarm email to a designated recipient.
4.5.1.8 Linking Buzzer
After a buzzer is linked, the alarm buzzer beeps when an alarm is triggered.
Steps
Enter the alarm configuration interface, and select Buzzer. See Figure 4-47.