User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
64
Show Message
Result Verification
Take the configuration of motion detection on alarm linking with screen output as an example.
When an alarm is triggered, the Alarm Status interface is displayed on the local interface of
the Device.
4.5.1.7 Linking Email Sending
After Email sending is linked, the system sends an alarm email to a designated recipient
when an alarm is triggered.
4.5.1.7.1 Configuring Email Settings
The alarm linking with mail sending is effective only when the email address, recipient and
other information are configured.
Select NETWORK > EMAIL.
The EMAIL interface is displayed. See Figure 4-45.