User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
61
3) Click OK.
Snapshot schedule appears on the Snapshot interface to view the configured
snapshot schedule directly.
Click Apply.
4.5.1.4.2 Enabling Automatic Snapshot
After automatic snapshot on channel is enabled, the channel starts alarm linking with
snapshot.
Right-click Manual > Record on the homepage.
The Record interface is displayed.
Enable the automatic snapshot on channel. See Figure 4-41.
Record
Click Apply.
4.5.1.4.3 Configuring Snapshot Linkage
Enter the alarm configuration interface, and select Snapshot. See Figure 4-42.