User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
59
Settings
Click to enable the alarm output.
Select a port for alarm output, and click OK.
Support multi-selection. One highlighted in blue means it is selected.
Configure alarm output delay.
Result Verification
When an alarm is triggered, the alarm output device gives an alarm, such as beep, light
flashing, etc.
4.5.1.4 Linking Snapshot
After snapshot is linked, the system starts snapshot by linking the channel when an alarm is
triggered.
4.5.1.4.1 Configure snapshot schedule
After motion detection on channel or alarm snapshot plan is enabled, the channel starts
alarm linking with snapshot.
Select Storage > Schedule > Snapshot under the main menu.
The Snapshot interface is displayed. See Figure 4-39.