User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
58
Record Channel
Select the record channel.
Support multi-selection. One highlighted in blue means it is selected.
Configure Delay.
4.5.1.2.4 Result Verification
Take the configuration of motion detection on alarm linking with video recording as an
example.
When an alarm is triggered, click or click the record time period on the time shaft to play
back alarm video after type, time, channel number, and record type are configured on the
Playback interface.
4.5.1.3 Linking Alarm Output
After alarm output is linked, the system gives an alarm by linking with the alarm output device
when an alarm is triggered. After an alarm ends, the alarm stops after an extended time
period according to the configured Alarm Delay.
Preconditions
The Device has been connected to the alarm output device, such as beeper, audible and
visual alarm, etc.
Steps
Enter the alarm configuration interface, click Setting of Alarm Output.
The Settings interface is displayed. See Figure 4-38.