User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
53
Motion detection
Select the channel number, and click to enable the motion detection for
the channel.
Configure jitter removal time and enable delay motion detection.
If there are multiple alarms during this period, the system records only one alarm
event.
After the delay motion detection is enabled, motion detection begins after a
period of time.
Set detecting area
1) Next to Region, click Setup.
The Area interface is displayed, see Figure 4-33.
The monitoring image is divided to 22×18(PAL) or 22×15(NTSC) blocks.
PAL (Phase Alteration Line) applies to the countries and regions
including China and Europe.
NTSC (Nation Television Standards Committee) applies to the
countries and regions including America and Japan.