User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
45
Alarm Output
Select alarm output mode.
Manual: After the alarm linkage is configured, no matter whether there is an
alarm event occurs, the corresponding alarm output port keeps generating
alarm.
Auto: After the alarm linkage is configured, when an alarm event occurs, the
corresponding alarm output port generates alarm.
Stop: After the alarm linkage is configured, no matter whether there is an alarm
event occurs, the corresponding alarm output port never generate alarm.
Click Apply.
View status of all alarm output ports under Status.
4.4.1.6 Multi-channel preview
Right-click Zero-Ch Encode on the preview interface.
The Zero-Ch Encode interface is displayed. See Figure 4-25.