User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
37
Common Operations
4.4.1 Live View
4.4.1.1 Previewing real-time pictures
After the Device is turned on, the multi-channel preview interface is displayed. See Figure
4-17. For icon descriptions, see Table 4-7.
TIPS
See .On the live view interface, the added remote device can be dragged to other
channel if needed.
You can view the information such as time, channel name, and recording and alarm
status in the channel view.
When you move the pointer to a channel window, the live view control bar is displayed.
Click to display the channel window upside down with left and right side reversed.
The preview mode by default is general. When the face detection is enabled, right-click
Preview Mode > Face on the preview interface. The face detected is displayed at the
bottom of the preview interface.
Preview