User's Manual
Table Of Contents
- Regulatory Information
- Cybersecurity Recommendations
- Foreword
- Important Safeguards and Warnings
- 1 Product Introduction
- 2 Dimension and Installation
- 3 Boot up the Device
- 4 Local Configurations
- 4.1 Initializing Device
- 4.2 Logging into the Device
- 4.3 Quick Configuration
- 4.4 Common Operations
- 4.5 Alarm Configuration
- 4.5.1 Alarm
- 4.5.2 Configuring Video Detection Settings
- 4.5.3 Configuring Alarm Events Settings
- 4.5.4 Abnormality
- 4.5.5 Configuring Alarm Output Settings
- 4.5.6 Searching Alarm Log
- 4.6 System config
- 4.7 System Update
- 4.8 System Maintenance
- 5 Web Operations
- 5.1 Initializing Device
- 5.2 Logging into the Device
- 5.3 Quick configuring
- 5.4 Common operations
- 5.5 System Settings
- 5.6 System Update
- 5.7 System Maintenance
- 6 Operating by DSS
- 7 FAQ
- Appendix 1 Mouse Operations
- Appendix 2 HDD Capacity Calculation
- Appendix 3 Technical parameters
35
Name
Description
Channel
Select a channel to configure the corresponding recording schedule. To
configure the same setting for all channels, select
All
Pre-record
Start recording for 0 seconds to 30 seconds before the alarm event occurs. If
you enter 0 seconds, there will be no pre-recording
Configure the recording time period.
1) Click corresponding to the week.
The Time Period interface is displayed. See Figure 4-14.
Time Period
2) Select the record type and weekday, and enter the recording period.
3) Click OK.
The recording schedule appears on the Record interface to view the configured
recording schedule directly.
Click Apply.
NOTE
Click Copy to copy the settings to other channels.
4.3.5.2 Configure snapshot schedule
After snapshot schedule is configured, the Device starts corresponding types of snapshot
according to the configured snapshot schedule.
Select Storage > Schedule > Snapshot under the main menu.
The Snapshot interface is displayed. See Figure 4-15.